Additional transmitters can be coded as follows: 1) Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes 2) Press the “+” button once (all LED lights turn off except LED 7) 3) Quickly press and release the required push button on your remote twice (all LED lights turn on and LED 7 will begin flashing) 4) Press the “P” button once to save (LED 3 will switch on indicating that the remote has been successfully programmed) If you fail to press the transmitter button whilst in coding mode within 7 seconds, the opener will automatically return to standby mode. Note: A maximum of 10 codes can be learned by the opener. If you want to program another transmitter and the memory is already full the first code will be deleted. Deleting transmitters: Note: This procedure will clear all programmed remotes, wireless wall buttons and wireless keypads from the opener. 1) Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes 2) Press and hold the “−“ button until LED 7 turns off and begins flashing again 3) Press the “P” button once to save (LED 3 will switch on indicating that all codes have been deleted and that the opener is now in normal operating mode) Follow Procedure 1. above to code new transmitters.
© Copyright NZ Garage Door Remotes | Owned by Auckland Garage Door Openers Limited - Site Map Phone: 0211724470 Auckland New Zealand