*** Hi Customers, please note we are taking a small break from weds 30th september until weds 7th of october so the last orders we will be sending out at 3.pm Tues 29th september then the next orders will go out on the 7th of october.for any Queries or tech suport needed for purchased products after the 30th sep please txt Nick on 027 300 7674 .Thanks For Your Suport**
4 button Replacement Garageace Orca Garage Door Remote Control,works For Motor Head In Picture Only
Programming the Remote Control (Transmitter):
The supplied Remote Control units can be programmed for any number
of purposes. Although the unit has four buttons, only one is needed to
operate the GarageAce. The same button will open and close the door.
If you have other devices (such as a burglar alarm) that can program a
remote control, use the other buttons for
Go To The Motor In Garage
A. Press K4 or The Code Button Depending Which Model Orca
and release until the LED displays
a dot. Press the preferred button
of Remote Control (Transmitter) then
release and press again. The dot will
flash to confirm the code.
B. Repeat step A for each Remote Control.
To delete all stored codes, press and hold K4 or Code Button for 8 seconds until the dot
turns off. All stored codes have now been deleted.
© Copyright NZ Garage Door Remotes | Owned by Auckland Garage Door Openers Limited - Site Map Phone: 0211724470 Auckland New Zealand