*** Hi Customers, please note we are taking a small break from weds 30th september until weds 7th of october so the last orders we will be sending out at 3.pm Tues 29th september then the next orders will go out on the 7th of october.for any Queries or tech suport needed for purchased products after the 30th sep please txt Nick on 027 300 7674 .Thanks For Your Suport**
1. Locate the Code Set button on your motor. Some motors
have a see-through plastic cover of the buttons, if so,
please remove this.
2. Press the Code Set button on the motor once and
immediately release. A red light on the motor will
3. Press and release the button on the new remote you wish
to code to the motor for 1-2 secs and the light on the
motor will begin to flash.
4. Press the same button on the new remote and the light
on the motor will stop flashing. The remote is now
programmed and will be able to operate the door.
© Copyright NZ Garage Door Remotes | Owned by Auckland Garage Door Openers Limited - Site Map Phone: 0211724470 Auckland New Zealand