Information
4332EBD/4332RBD 062171 BND 62171 Garage Remote
Suitable for the following openers:
Replacement Keyring Remote Has 9 dipswitches Same As Old Remote
B&D Controll-A-Door 4 (CAD4)
B&D Controll-A-Door 5 (CAD5)
B&D Controll-A-Door P (CADP)
B&D Controll-A-Door R (CADR)
***not suitable for 27mhz old Remote with Ribbed button on left***
Coding Instructions
How to store the transmitter code: The opener can only operate from transmitters that have been programmed into its receiver. The receiver needs to learn the codes of any transmitter that will be used with the opener. Up to fourteen (14) codes can be stored in the receiver's memory.
a. Go To The Garage Door Motor In Garage And Locate Learn Or Code Set Button
Controla door for =square green button on back motor panel
Cad-p diamond=orange square button on back panel
Roller door motors=code set button on side of motor
1. Press and hold the button on the hand-held remote* that you wish to operate your garage door.
2. Press and release the Learn button on the back panel of the opener.
3. The light globe will blink when the code has been accepted. If the light globe is not installed, two clicks will be heard.
To Erase All Codes From Opener Receiver Memory
To deactivate any unwanted remote, first erase all codes:
1. Press and hold the “Smart” button on opener until the smart indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.